Barco G62 - Installing the Lens Safety Cable

21R5914654 /00 G62
1 3G-SDI cable
2 3D Sync cable
3 3D Emitter cable
4 HDMI cable
5 USB cable
6 HDMI cable
7 DVI cable
8 RS232 cable
9 Power cord
Notes on wiring diagram:
• The diagram shows the cables/connectors that may be used to connect to various devices.
• Due to the difference in applications for each country, the accessories required in some regions may be
different from those shown.
• This diagram is for illustrative purposes only, and does NOT indicate that these accessories are supplied
with the projector.
2.5 Connecting to video sources
Wiring diagram
DC 12 V
HDB as eT
HDM I OU T
HDM I- 2 IN
HDM I- 1 IN
DVI -D
3G- SD I IN
ETH ER NE T
USB
3D SY NC
IN
RS2 32
REM OT E
IN
OUT
3D SY NC
Component video output
equipment
DVD PlayerVideo cassette recorder
1 2
1
2
Image 2–8
1 HDMI cable
2 HDMI cable
Notes on wiring diagram:
• The diagram shows the cables/connectors that may be used to connect to various devices.
• Due to the difference in applications for each country, the accessories required in some regions may be
different from those shown.
• This diagram is for illustrative purposes only, and does NOT indicate that these accessories are supplied
with the projector.
2.6 Ceiling mount installation
Requirements
To prevent damage to your projector, please use a Barco recommended ceiling mount. Ensure the screws
used to install the mount to the projector meet the following specifications:
• Screw type: M6 x 4
• Mounting holes (reference 1, see illustration below)
Installation