Barco G62 - Page 33

33R5914654 /00 G62
1
3
2
Image 4–8
Note: This process may cause the other areas of the image to slide out of focus. This is totally
normal.
4. If zone H is in focus on the screen, please check the focal plane of zone I.
• If clear position is just on the screen→ No need to adjust.
• If clear position is out of the screen(cloe to projector), rotate screw ③ CCW and then screw ① & ② CW
for half amount that ③ rotated. → repeat until both H and I are clear. (e.g. turning ③ CCW in a circle,
then turn ① & ② CW in half circle).
• If clear position is in the screen(far from projector), rotate screw ③ CW and then screw ① & ② CCW
for half amount that ③ rotated. → repeat until both H and I are clear.
Adjusting the projected image