75R5900049 /13 ClickShare CSE-800
3. Click on the drop down box and select the desired mode.
The following modes are available
• Extented
• Clone
• Span
4. Click on Save changes to apply the new settings.
Screen saver setup
1. Log in to the Configurator.
2. Click Display & Audio → Outputs.
3. To activate the screen saver, drag the slider bar to the left or to the right until the desired delay time is
reached.
When the slider is set completely to the left, the screen saver will never be activated.
4. Click on Save changes to apply the new settings.
Screensaver mode
The screensaver mode can be set to an external source. The HDMI input can be configured to be used as
screensaver. E.g. a room PC connected to the unit to display signage content when the Base Unit is not being
used for content sharing.
Click on the drop down box next to screensaver mode and make your selection between default and HDMI.
6.9 Audio settings
About the audio settings
The audio functionality can be disabled or enabled. When the enable and/or disable setting is changed, the
Buttons must be re-paired before the setting becomes active.
How to change
1. Log in to the Configurator.
2. Click Display & Audio → Display & Audio → Output.
Image 6–20 Audio settings
3. Check or uncheck the check box next to Enable Audio.
Checked: audio is enabled.
CSE-800 Configurator
To Next Page
Loading...
