R5900049 /13 ClickShare CSE-80078
Image 6–23 Wi-Fi settings, edit
Operational mode
1. Log in to the Configurator.
2. Click Wi-Fi & Network → Wi-Fi Settings.
3. Click Edit settings.
4. Click on the drop down box next to Operational Mode and select the desired mode.
The following options are possible:
• Access Point: continue with the next blocks in this topic.
• Off
Wi-Fi passphrase
1. Enter a new Wi-Fi passphrase.
2. Confirm that new Wi-Fi passphrase.
CAUTION: It is strongly recommended to change the Wi-Fi passphrase on first use to prevent
anyone else accessing the Wi-Fi network.
Signal strength
1. Select the Signal Strength. Click on the slider and reduce the broadcasted power (signal strength) until the
desired strength is obtained.
Note: Too low power and interference by others might lead to connection issues. If so, increase again
the signal strength until the issues are solved.
By default the strength is set to 100%.
CSE-800 Configurator
To Next Page
Loading...
