Barco UDM 4K22 - Installation Procedures

45R5911438 /09 UDM
4.1 Pulse RCU, battery installation ......................................................................................................46
4.2 Connecting the projector with the power net....................................................................................48
4.3 Displaying and Programming addresses into the RCU.....................................................................49
4.4 Using the XLR connector of the RCU .............................................................................................50
4.5 Setting the projector addresses .....................................................................................................51
4.6 Alignment of a table mounted projector...........................................................................................52
4.7 Alignment of projector in the rigging frame ......................................................................................53
4.8 Wall or ceiling mount without rigging frame .....................................................................................54
4.9 Installation of an input board..........................................................................................................55
4.10 Removal of an input board.............................................................................................................57
4.11 Software update ...........................................................................................................................58
About this chapter
This chapter describes all basic procedures for the physical installation of the projector.
Installation
procedures
4