To Next Page
S
Stacy JenkinsAug 1, 2025
What to do if my Barco SIM 7D lamp is off in standby mode?
- DDawn MillerAug 1, 2025
If the lamp on your Barco Projector is off while in standby mode, switch the projector to an active state.
What to do if my Barco SIM 7D lamp is off in standby mode?
If the lamp on your Barco Projector is off while in standby mode, switch the projector to an active state.
How to fix blurry image on Barco SIM 7D Projector?
To correct a blurry image on your Barco Projector, adjust the lens focus.
Why is my Barco SIM 7D overheating with INTERNAL TEMP. error?
If your Barco Projector shows an 'INTERNAL TEMP.' error because the temperature is out of range, clean or replace the air filter.
What to do if the mains switch is off on Barco Projector?
If the mains switch is off on your Barco Projector, switch it ON.
Highlights critical safety precautions and warnings before projector installation.
Explains the process of installing and adjusting projection lenses, including Scheimpflug.
Covers adjustments like locking the lens holder, zoom, focus, and back focal length.
Covers image settings such as contrast, brightness, gamma, and phase.
Describes geometry correction files and adjustments for screen matching.
Information on lamp runtimes, warnings, history, and power modes.
Provides recommendations and procedures for safely cleaning the projector lens.
Covers the process and importance of replacing air filters to maintain projector performance.
Details the procedures for safely replacing the projector lamp and resetting runtime.
Offers a first-level guide to identify and resolve common projector issues.
General
