7. Advanced
7.8.8 TMR
What can be done ?
TMR can be put ON or OFF. The TMR is factory adjusted to guarantee optimal performance.
How to enable the TMR ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select TMR
5. Press → to pull down the menu
6. Use ↓ or ↑ to select ON/OFF to enable/disable the TMR
Image 7-124
7. Press ENTER
A white bullet show the active setting
7.8.9 Color temperature
What can be done ?
Changing the Color temperature changes the coordinates of the white point of the projector. The color temperature can be selected
according to the type of source: next to Pro jector wh
ite, which is brightest white point that can be produced by the projector, 5
different presets are available:
•Projectorwhite
• Computer : 9300 K
• Video : 6500 K
• Film : 5400 K
• Broadcast : 3200 K
• Dynacolor white
These calibrated presets can be selected and will provide optimum color tracking. The projector however allows the setting of a
personal color temperature: this is done by changing the white point coordinates in Dynacolor.
Changing the color temperature while Dynacolor is enabled, will change the coordinates of the desired value
of the white point in the Dynacolor user interface.
If Dynacolor is enabled and the white point coordinates have been changed there, then the color temperature
will be set to Dynacolor white and the value will match the coordinates of the white point in the desired values
of the Dynacolor user interface.
R59770198 BARCO SIM 7D 13/02/2013 119
To Next Page
Loading...
Need help?
General
