7. Advanced
Image 7-89
A dialog box is displayed
Image 7-90
7. Starting at the lowest value, increase the value in steps of 100 until you get to the range where frame tearing is clearly visible
Tip: Use the arrow keys, the num eric k eys on the remote, or the keyp
ad to change the Sync variance limit
8. Further increase the value until this frame tearing disappears again
9. Increase the actual value by 100 or 200
7.8.5 Soft edge
The soft edge adjustment is done on the hand held remote control unit RACU. The soft edge adjustment menu
on the projector should only be used for demo purposes.
Overview
• Introduction
• Accessing the Soft edge menu
• Soft edge edit
•Blacklevel
• Blanking
7.8.5.1 Introduction
What can be done?
When working in a multichannel setup the Soft edge feature enables an image blending that gives the appearance of a single image,
thus achieving realistic immersion for the majority of simulation and virtual reality applications.
100
R59770198 BARCO SIM 7D 13/02/2013
To Next Page
Loading...
