Barco SIM 7D - Connecting a DVI Source; Source Specification; Connections: Connecting a DVI Source

4. Installation
4.7.2.3 Connecting a DVI source
How to connect a DVI source ?
1. Connect the dual channel image generator source to the projector by connecting the DVI male connector of channel 1 into the
projector’s DVI 1 female input connector and the DVI male connector of channel 2 in the DVI 2 female input connector
IG
Channel 1
Channel 2
Image 4-32
Connections : connecting a DVI source
4.7.2.4 Source specification
What are the required source specifications ?
In order to allow a perfect display of the 2 frustum images i.e. a perfect overlap and perfect alignment with respect to the display
area, the source must meet the following specifications.
• Source resolution (per frustum) : 1184 horizontal x 1536 vertical pixels
• Vertical refresh rate : 60 Hz
Howwillthetotalimagebeformed?
The total image on projector level will be formed using electronic soft edge matching between the 2 channels (frustums) hereby
creating an overlap zone. The image can be warped in order the match the screen curvature.
28
R59770198 BARCO SIM 7D 13/02/2013