Barco SIM 7D - Adjusting the Image; Switching the Projector to Standby

6. Getting started
6.3 Adjusting the image
How to adjust the image ?
1. Use the Image setting buttons on the RCU
AUT
AUT
O IMAGE
O IMAGE
PC
PC
RGB
RGB
VIDEO
VIDEO
Fire W
Fire W
ire
ire
DVI
DVI
IQ-PC
IQ-PC
SDI
SDI
S-VIDEO
S-VIDEO
PHASE
PHASE
TINT
TINT
COLOR
COLOR
BRIGHTN
BRIGHTN
CONTR
CONTR
ZOOM
ZOOM
DIGI
DIGI
9
0
7
8
5
6
3 4
1
2
Image 6-3
6.4 Switching the projector to standby
Introduction
If the projector is not to be used for a period of time (hours, days), it is advised to switch it to standby to save energy or it can be
fully powered off after the cooling cycle. The advantage of standby mode compared to power off mode is the time to get it back to
active state (i.e. lamp on).
After switching the projector to standby, the lamp is switched off and the cooling cycle is started (two minutes). Do not power off
the projector during the cooling cycle since doing so reduces the lamp life time.
Switching to standby
1. While the projector is in active state, keep the Standby button on the RCU or on the local keypad pressed for two seconds.
2. The lamp is switched off and the two minute cooling cycle is started.
52
R59770198 BARCO SIM 7D 13/02/2013