7. Advanced
• Limited scan: a windowing system is used to allow fast tracking.
The operation takes about 20 seconds (depending on file)
• Full scan: tracking is done over the full range.
The operation takes about 1.5 minutes (depending on file)
HowtolaunchAutoImage?
1. Press MENU to activate the Tool bar
2. Press → to select the Image fi les item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Auto Image
5. Press → to open the menu
6. Use ↑ or ↓ to select the desired file scan method
Image 7-14
7. Press ENTER
AutoImage acts on the active window. The image in the window may move and change in aspect during the
AutoImage process.
Auto Image can also be launched via the RCU with the dedicated AutoImage key.
7.4.3 Edit file
What can be done with the Edit file menu ?
The Edit file menu makes it possible to change the settings of the file according to the real settings of the connected source. Consult
the source specifications before entering the data.
In this case a DVI source is used. A DVI source does not need any image file setting. All the fields are therefore
greyed out. See the dialog box below.
How to edit a fi le ?
1. Press MENU to activate the Tool bar
2. Press → to select the Image fi les item
3. Press ↓ to Pull down the Image files menu
4. Use ↑ or ↓ to select Edit
R59770198 BARCO SIM 7D 13/02/2013
61
To Next Page
Loading...
