7. Advanced
How to start up Dynacolor?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynacolor
5. Press → to open the menu
6. Use ↑ or ↓ to select Mo de
7. Press → to open the menu
8. Use ↑ or ↓ to select ON
Image 7-132
9. Press ENTER
A white bullet indicates the active setting
7.8.10.3 Dynacolor adjustment
Overview
• Introduction
• Calibration (for multiple projectors)
• Common color values
• Factory preset
7.8.10.3.1 Introduction
In multiple channel setup, it might be needed to align the colors of every projector in order to match the colors
of the others in a prefect way. Only this case where multiple projector have to be color matched is covered in
the procedure below.
Dynacolor adjustment versus Dynacolor calibration
• Single channel setup: each projector is color calibrated during production. This means that projectors in single channel setup
do not need to be calibrated anymore. Only specific color requests from the user may require some DynaColor adjustment.
This can be easily done by SLIGHTLY changi
ng the desired values.
• Multiple channel setup: in multiple channel setup, it might be needed to align the colors of every projector in order to match the
colors of the other projectors in a prefect way. Only this case where multiple projector have to be color matched may require a
calibration.
Dynacolor adjustment
To adjust the Dynacolor settings, it is sufficient to change the values in the field Desired of the user interface.
R59770198 BARCO SIM 7D 13/02/2013
125
To Next Page
Loading...
