Barco SIM 7D - Installing the Electronics Filter; Electronics Filter: Removing; Electronics Filter: Install; Electronics Filter Cover: Mounting

8. Maintenance
Image 8-13
Electronics filter: removing
8.3.4 Installing the electronics filter
Necessary tools
Torx screwdriver T10
How to install the electronics filter?
1. Insert the electronics filter in its housing until it sticks out only
a few centimeters
Image 8-14
Electronics filter: install
Note: The sea l of the air filter m ust po int down!
Note: The obliged air flow direction is indica ted by a n arrow on the label at the edge of the air filt er.
2. Place the electronics filter cover against the electronics filter
Image 8-15
Electronics filter cover: mounting
Image 8-16
Exact position of the cover against the electronics filter
3. Push the electronics filter completely in its housing
R59770198 BARCO SIM 7D 13/02/2013
157