4. Installation
Also see the lens connection procedure.
4.6 Projector configuration
The different configurations
Depending on the installation the projector can be mounted in different ways, the 4 different configur
ations are:
1. Rear/Ceiling
2. Rear/Table
3. Front/Ceiling
4. Front/Table
1
2
3
4
Image 4-26
Projector configurations
4.7 Connections
Overview
• Power connection
• Signal connections
• Communications
4.7.1 Power connection
Voltage, Ampere, Frequency rating
Projector type
Voltage range (AC) Current
Frequency
SIM 7
100 – 240 V single phase 6 – 3 A 50 – 60 Hz
How to connect the power ?
1. Use the supplied power cord to connect the projector to the power outlet.
2. Plug the female power connector into the male connector at the rear of the projector
R59770198 BARCO SIM 7D 13/02/2013
25
To Next Page
