Barco SIM 7D - Image Settings; Setting the Brightness; Setting the Contrast

7. Advanced
The adjustments done in the Image menu are saved in the corresponding image file and only affect the active
source, whereas adjustments done in the Display settings are applied to all sources.
7.3.2 Image settings
Overview
• Setting the Contrast
• Setting the Brightness
• Gamma
• Phase (RGB signals only)
7.3.2.1 Setting the Contrast
Contrast adjustments
Adjust the contrast to “brighten” the white parts of the image.
It is recommended to adjust the brightness before adjusting the contrast.
How to change the Contrast
1. Press MENU to activate the Tool bar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select settings
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Co ntrast
7. Press ENTER
On the screen appears now a slider box
Image 7-6
8. Use ←or → , the numeric keys on the remote, or the keypad to change the contrast
7.3.2.2 Setting the Brightness
Brightness adjustment
Adjusting the brightness will affect the dark areas of the image. Increase the brightness to “lighten” up the parts that are too dark.
How to change the Brightness
1. Press MENU to activate the Tool bar
2. Press → to select the Image item
3. Press ↓ to Pull down the Image menu
4. Use ↑ or ↓ to select settings
5. Press → to pull down the menu
6. Use ↑ or ↓ to select Brightness
7. Press ENTER
56
R59770198 BARCO SIM 7D 13/02/2013