7. Advanced
4. Use the cursor key ↑ and ↓ to select the desired geometry file and press ENTER to select.
A message will be displayed.
Image 7-68
5. Press ENTER to confirm.
The selected fi le is deleted and removed from the list.
6. Press BACK to return to the Geometry Edit menu.
7.6 Lamps
CAUTION: Read the section about the warranty of lamps in relation to the runtime mode on "Warranty: con-
tinuous mode / automatic shutdown mode", page 37.
Overview
• Runtimes
• Lamp runtime warning
•History
• Reset lamp Runtime
• Lamp power mode
• CLO Mode
7.6.1 Runtimes
Typical runtime
The lamp for this projector has its typical runtime. It must be replaced when the runtime is reached.
When this runtime is reached, a warning will be displayed on the projected image and the warranty will have expired. The warning
message can be removed from the image by pressing the Back key on the RCU, but it will pop-up again every time the projector is
switched to the active state, until the lamp has been replaced.
How to display the runtimes ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamps item
3. Press ↓ to pull down the Lamps menu
4. Use ↑ or ↓ to select Runtimes
Image 7-69
5. Press ENTER
90
R59770198 BARCO SIM 7D 13/02/2013
To Next Page
Loading...
