7. Advanced
A dialog box appears:
Image 7-78
3. Confirm by selecting Yes .
A drop or rise in light output is noticed.
7.6.6 CLO Mode
The adjustment and calibration of the CLO is done via the hand held control unit RACU. For more information,
see the dedicated system manual.
7.6.6.1 Constant Light Output (CLO)
When activating the projector with CLO enabled, the CLO will only become active after 3 minutes.
What can be done?
Constant Light Output allows to force a constant light output (set in the CLO Target ... menu) of the projector over a certain period.
This will eliminate uncontrolled light output drop caused by natural aging of the lamp. The CLO is done by automatically adjusting
the Dimmer.
How to set the CLO On or Off ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamps item
3. Press ↓ to pull down the Lamps menu
4. Use ↑ or ↓ to select CLO Mod e
5. Press → to pull down the menu
6. Use ↑ or ↓ to select CLO
7. Press → to pull down the menu
8. Use ↑ or ↓ to select ON or OFF
Image 7-79
9. Press ENTER
94
R59770198 BARCO SIM 7D 13/02/2013
To Next Page
Loading...
Need help?
General
