155R5911443 /11 UDM
Image 10–42 Example of the Date and time menu
2. Disable the Automatic slider.
Gray slider: automatic is off
Blue slider: automatic is on
3. Select Date
The Date dialog is prompted. The active day is selected by default.
4. Slide the Day, Month and Year slider up or down until the desired date is obtained.
or
Alternatively, use the up, down and OK buttons on the RCU or control panel until the desired date is
obtained.
5. Select Time.
The Time dialog is prompted. The active time is selected by default.
6. Slide the Hour, Minute and second slider up or down until the desired time is obtained.
or
Alternatively, use the up, down and OK buttons on the RCU or control panel until the desired time is
obtained.
7. Select Apply to activate.
10.12 Date and time setup - automatically
Date is displayed by default as: day / month / year.
Time is displayed by default as: hour : minutes : seconds, in the 24–hour clock.
To set date and time automatically
1. In the main menu, select Settings → Date and time.
Image 10–43
The Date and time menu is displayed.
GUI – System Settings
To Next Page
Loading...
