Barco UDM Series - LED and Button Indication Chart

43R5911438 /08 UDM
4.1 Pulse RCU, battery installation ......................................................................................................44
4.2 Connecting the projector with the power net....................................................................................46
4.3 Displaying and Programming addresses into the RCU.....................................................................47
4.4 Using the XLR connector of the RCU .............................................................................................48
4.5 Setting the projector addresses .....................................................................................................49
4.6 Alignment of a table mounted projector...........................................................................................50
4.7 Alignment of projector in the rigging frame ......................................................................................51
4.8 Wall or ceiling mount without rigging frame .....................................................................................52
4.9 Installation of an input board..........................................................................................................53
4.10 Removal of an input board.............................................................................................................55
4.11 Software update ...........................................................................................................................56
About this chapter
This chapter describes all basic procedures for the physical installation of the projector.
Installation
procedures
4