Barco UDM Series - GUI - Installation

To Next Page

To Previous Page

75R5911438 /08 UDM

6.1 Flight case ...................................................................................................................................76

6.2 Rigging frame...............................................................................................................................77

About flight case and rigging frame

The projector can also be delivered with rigging frame installed inside a flight case.

Flight case and

rigging frame

Main Page

Table of Contents5
Safety Information7
General Considerations8
Important Safety Instructions10
Product Safety Labels14
High Brightness Precautions: Hazard Distance15
HD for Fully Enclosed Projection Systems17
HD in Function of Modifying Optics18
Radio Equipment (Optional)19
Compliance20
Download Product Manual21
Installation Process23
Preparation Process24
Installation Process25
Additional Install Options27
Prepare to Install29
Installation Requirements30
Unpacking the Projector32
Initial Inspection34
Projector Orientations35
Projector Positioning37
Projector Shift and Tilt Range38
Lens Selection39
Available Lenses40
Download Projector Toolset42
Installation Procedures43
Pulse RCU, Battery Installation44
Connecting the Projector with the Power Net46
Displaying and Programming Addresses into the RCU47
Using the XLR Connector of the RCU48
Setting the Projector Addresses49
Alignment of a Table Mounted Projector50
Alignment of Projector in the Rigging Frame51
Wall or Ceiling Mount Without Rigging Frame52
Installation of an Input Board53
Removal of an Input Board55
Software Update56
Lenses59
Lens Installation60
Installing the Lens Safety Cable62
Lens Removal66
UST Lenses68
About UST Lenses68
Installation of the Lens Safety Cable on the UST Lens69
Installing the UST Lens69
Adjustment of the UST Lens70
Change the Motor Block Orientation71
Flight Case and Rigging Frame75
Flight Case76
Rigging Frame77
Pulse SFP Input Use Cases79
Use Case 1: SFP+ Transceiver + Fiber Connection (Integrated or Separated)80
Use Case 2: Neutrik Opticalcon Duo + SFP+ Transceiver + Internal Fiber81
Use Case 3: Neutrik Opticalcon Quad + SFP+ Transceiver + Internal Fiber82
Use Case 4: Loop-Through Mode83
Projector Covers85
Cover Locks86
Removal of the Front, Side and Rear Covers87
Removal of Top Cover88
Installing the Projector Covers89
A Dimensional Drawings91
Dimensions of the Projector92
Dimensions of the Rigging Frame93
Dimensions of the Flight Case94
Glossary95
List of Tools97
Index99

Barco UDM Series - GUI - Installation

Table of Contents

Other manuals for Barco UDM Series

Related product manuals