BARKO LOADERS 295 - Page 11

page 11
295 AC
800-00158
WARNING
Improper load handling and/or hydraulic pressure
loss can cause load to impact cab guard,
resulting in death or severe injury.
- Do not rely on guard alone for personal
protection. Use safe and proper load
handling techniques.
- Do not operate machine with damaged or
unsecured guard or cab.
- Do not repair damaged guard. Replace with
factory-authorized guard.
- Do not modify guard without factory
authorization.
- Do not operate before conducting Pre-Start
Maintenance Inspection. Check hydraulic
components for leaks, loose fittings or
damage.
WARNING
High pressure hydraulic fluid can penetrate skin
causing death, gangrene or other severe injury.
Seek immediate medical help to remove fluid.
- Keep hands and body away from areas
ejecting fluid. Use piece of cardboard to
check for leaks. Wear proper hand and eye
protection.
- Relieve hydraulic pressure before loosening
any hydraulic connections.
- Tighten all hydraulic connections before
applying hydraulic pressure.
WARNING
Always maintain 3-point contact with handles and
steps when mounting or dismounting. Never
jump on or off machine. Do not rush. Walk, do
not run.
WARNING
Mechanically connected controls will cause
movement of components at all times - even if
pump or engine is not operating. Always be
certain that boom and attachment are properly
supported or resting on firm ground before
stopping engine to minimize chance of
accidental movements of components causing
death, severe injury or property damage.
WARNING
Grease all boom, cylinder, and turntable bearing/
pinion points daily.
WARNING
Transparent material such as safety glass must be
replaced when it is cracked or broken, or when
vision is obscured due to scratches.
WARNING
Loose or overtorqued bolts can cause death,
severe injury, or property damage. Maintain
proper bolt torque. Visually check bolts daily.
Check torque every 50 hours.
WARNING
Remove or secure all personal or maintenance
items such as lunch buckets, chains, shovels,
tools, etc., before moving or operating machine.
WARNING
Replace any safety decals that are faded, torn,
missing, illegible, or otherwise damaged.
SAFETY SUMMARY CONTINUED...
WARNING
Make sure that all walking and climbing surfaces
of machine are free of dirt, debris, water, grease,
oil, and snow. Do not leave loose tools or rags
on machine. Replace all non-skid material that is
torn, missing or damaged.