Barko 6025 - Preventive Maintenance; Special New-Machine Instructions

page 19page 19

page 19

240 Harvester Feller/

Buncher

Preventive maintenance is really just a simple matter of common sense. If you keep any piece of mechanical

equipment clean and properly lubricated, and promptly replace any worn or damaged parts, you are going to

"prevent" deterioration and promote long life and safe, productive service. The only other requisite to such a program

is the regular scheduling of such maintenance.

Obviously, when you are operating under severe job conditions, such as a dusty job site, in extreme heat or cold, a

long operating day, or extremely heavy loads, the recommended intervals in the schedule should be shortened.

The suggested schedule on the following page is designed to be just a reminder of what should be done. For

detailed instructions on each item, consult the Table of Contents for where each is located in this manual.

AFTER THE FIRST 100 HOURS OF OPERATION OF A NEW MACHINEAFTER THE FIRST 100 HOURS OF OPERATION OF A NEW MACHINE

AFTER THE FIRST 100 HOURS OF OPERATION OF A NEW MACHINE

A new machine needs a special maintenance procedure after the first 100 hours of operation.

1. Do a complete inspection of the Chipper. Rectify any problems, replace any damaged parts.

2. Check torque (retorque if necessary):

- Mounting Bolts/Nuts on major machine components (gearboxes, motors, pumps, booms,

attachment, turntable bearing, lower assembly, tires, etc.)

3. Check torque of Chipper mounting bolts. Retorque if necessary.

4. Change all filter elements.

Resume the normal maintenance intervals after this. See the Service Schedule for more information.

SPECIAL NEW-MACHINE INSTRUCTIONSSPECIAL NEW-MACHINE INSTRUCTIONS

SPECIAL NEW-MACHINE INSTRUCTIONS

PREVENTIVE MAINTENANCEPREVENTIVE MAINTENANCE

PREVENTIVE MAINTENANCE

WARNING WARNING

WARNING

Instructions are necessary before doing service onInstructions are necessary before doing service on

Instructions are necessary before doing service on

loader. See warnings and instructions both at theloader. See warnings and instructions both at the

loader. See warnings and instructions both at the

beginning and throughout this manual. After doingbeginning and throughout this manual. After doing

beginning and throughout this manual. After doing

service or making repairs or adjustments always checkservice or making repairs or adjustments always check

service or making repairs or adjustments always check

function of loader.function of loader.

function of loader.

Safety glasses or goggles are always needed for eyeSafety glasses or goggles are always needed for eye

Safety glasses or goggles are always needed for eye

protection from electric arcs, from shorts or welding,protection from electric arcs, from shorts or welding,

protection from electric arcs, from shorts or welding,

battery acid, compressed springs, fluids under pressure,battery acid, compressed springs, fluids under pressure,

battery acid, compressed springs, fluids under pressure,

and flying debris or loose material when engines areand flying debris or loose material when engines are

and flying debris or loose material when engines are

running or tools are used. Use eye protection approvedrunning or tools are used. Use eye protection approved

running or tools are used. Use eye protection approved

for type of welding. Failure to obey warnings can causefor type of welding. Failure to obey warnings can cause

for type of welding. Failure to obey warnings can cause

death, severe injury or property damage.death, severe injury or property damage.

death, severe injury or property damage.