page 25page 25
page 25page 25
page 25
240 Harvester Feller/
Buncher
SPECIAL TORQUE SPECIFICATIONSSPECIAL TORQUE SPECIFICATIONS
SPECIAL TORQUE SPECIFICATIONSSPECIAL TORQUE SPECIFICATIONS
SPECIAL TORQUE SPECIFICATIONS
WARNING WARNING
WARNING WARNING
WARNING
Loose or overtorqued bolts can cause death, severe injury, or propertyLoose or overtorqued bolts can cause death, severe injury, or property
Loose or overtorqued bolts can cause death, severe injury, or propertyLoose or overtorqued bolts can cause death, severe injury, or property
Loose or overtorqued bolts can cause death, severe injury, or property
damage. Maintain proper bolt torque. Visually check bolts daily. Checkdamage. Maintain proper bolt torque. Visually check bolts daily. Check
damage. Maintain proper bolt torque. Visually check bolts daily. Checkdamage. Maintain proper bolt torque. Visually check bolts daily. Check
damage. Maintain proper bolt torque. Visually check bolts daily. Check
torque every 100 hours.torque every 100 hours.
torque every 100 hours.torque every 100 hours.
torque every 100 hours.
WARNING WARNING
WARNING WARNING
WARNING
In critical applications (such as Turntable Bearing Bolts and any grade 8In critical applications (such as Turntable Bearing Bolts and any grade 8
In critical applications (such as Turntable Bearing Bolts and any grade 8In critical applications (such as Turntable Bearing Bolts and any grade 8
In critical applications (such as Turntable Bearing Bolts and any grade 8
or grade 9 bolts), once the old bolts and nuts have been loosened, theyor grade 9 bolts), once the old bolts and nuts have been loosened, they
or grade 9 bolts), once the old bolts and nuts have been loosened, theyor grade 9 bolts), once the old bolts and nuts have been loosened, they
or grade 9 bolts), once the old bolts and nuts have been loosened, they
must be replaced rather than re-tightened and re-torqued. Originalmust be replaced rather than re-tightened and re-torqued. Original
must be replaced rather than re-tightened and re-torqued. Originalmust be replaced rather than re-tightened and re-torqued. Original
must be replaced rather than re-tightened and re-torqued. Original
clamping force cannot be achieved using the old bolts and nuts.clamping force cannot be achieved using the old bolts and nuts.
clamping force cannot be achieved using the old bolts and nuts.clamping force cannot be achieved using the old bolts and nuts.
clamping force cannot be achieved using the old bolts and nuts.
Other torques, for the valves, pumps, and motors are found in the service literature for those components.
6025 CHIPPER6025 CHIPPER
6025 CHIPPER6025 CHIPPER
6025 CHIPPER
To Next Page
Loading...