page 52page 52
page 52page 52
page 52
240 Harvester Feller/
Buncher
DON'TDON'T
DON'TDON'T
DON'T
REMOVE REMOVE
REMOVE REMOVE
REMOVE
ELEMENT FORELEMENT FOR
ELEMENT FORELEMENT FOR
ELEMENT FOR
INPECTIONINPECTION
INPECTIONINPECTION
INPECTION
Such a check will always do more harm to your engine
than good. Ridges of dirt on the gasket sealing surface
can drop on the clean filter side when the gasket is
released. Stick with the schedule. If you are on
restriction maintenance, follow your reading or get a new
indicator if you don't trust it.
NEVERNEVER
NEVERNEVER
NEVER
RAP AN RAP AN
RAP AN RAP AN
RAP AN
ELEMENT TO CLEANELEMENT TO CLEAN
ELEMENT TO CLEANELEMENT TO CLEAN
ELEMENT TO CLEAN
IT. THIS WILL ONLYIT. THIS WILL ONLY
IT. THIS WILL ONLYIT. THIS WILL ONLY
IT. THIS WILL ONLY
DESTROY IT.DESTROY IT.
DESTROY IT.DESTROY IT.
DESTROY IT.
Rapping hard enough to knock off dust often damages
the element and destroys your engine protection.
Deeply embedded dirt is never released by tapping. It's
always safer to keep operating until you can change to a
fresh filter.
NEVER NEVER
NEVER NEVER
NEVER
JUDGEJUDGE
JUDGEJUDGE
JUDGE
YOUR ELEMENT'SYOUR ELEMENT'S
YOUR ELEMENT'SYOUR ELEMENT'S
YOUR ELEMENT'S
LIFE BY LOOKINGLIFE BY LOOKING
LIFE BY LOOKINGLIFE BY LOOKING
LIFE BY LOOKING
AT IT.AT IT.
AT IT.AT IT.
AT IT.
A dirty filter may still have plenty of life left, while carbon
contamination is not visible to the eye. And you can't see
the dirt that is embedded deep within the filter paper.
Your best bet for lowest filter maintenance costs and best
engine performance is to follow a restriction gauge. It's a
smart, low-cost investment.
NEVERNEVER
NEVERNEVER
NEVER
LEAVE AN LEAVE AN
LEAVE AN LEAVE AN
LEAVE AN
AIR CLEANER OPENAIR CLEANER OPEN
AIR CLEANER OPENAIR CLEANER OPEN
AIR CLEANER OPEN
LONGER THANLONGER THAN
LONGER THANLONGER THAN
LONGER THAN
NECESSARY.NECESSARY.
NECESSARY.NECESSARY.
NECESSARY.
Your open air cleaner is a direct entry to your engine. If
the element is not going to be changed and
reassembled immediately, cover the opening. The only
way to be sure nothing got in is to be sure nothing gets in.
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
THE IMPORTANT "DON'TS" TO ALWAYS REMEMBER:
DON'TDON'T
DON'TDON'T
DON'T
OVERLOOK AOVERLOOK A
OVERLOOK AOVERLOOK A
OVERLOOK A
WORN ORWORN OR
WORN ORWORN OR
WORN OR
DAMAGED GASKETDAMAGED GASKET
DAMAGED GASKETDAMAGED GASKET
DAMAGED GASKET
IN THE HOUSINGIN THE HOUSING
IN THE HOUSINGIN THE HOUSING
IN THE HOUSING
If your cleaner has a cover gasket, replace it with a new
one. Always check to be sure no piece of the old gasket
remains in the housing and that the gasket is not worn. If
your filter model calls for a new gasket with each use,
never reuse the old one.
DON'TDON'T
DON'TDON'T
DON'T
USE A USE A
USE A USE A
USE A
DENTED ORDENTED OR
DENTED ORDENTED OR
DENTED OR
BUNCHED FILTERBUNCHED FILTER
BUNCHED FILTERBUNCHED FILTER
BUNCHED FILTER
ELEMENT.ELEMENT.
ELEMENT.ELEMENT.
ELEMENT.
Never install a dented or punctured element, because it
cannot protect properly against contamination. A dent
can make a firm seal impossible or can indicate
damaged media. An element with bunched pleats saps
engine power and fuel dollars right from the start.
NEVERNEVER
NEVERNEVER
NEVER
USE A USE A
USE A USE A
USE A
WARPED COVERWARPED COVER
WARPED COVERWARPED COVER
WARPED COVER
ON A HOUSINGON A HOUSING
ON A HOUSINGON A HOUSING
ON A HOUSING
Replace with a new cover as soon as possible. A
warped or damaged cover cannot make a proper seal.
Also check to make sure there is no damage to the air
cleaner housing that could cause a leak.
NEVERNEVER
NEVERNEVER
NEVER
SUBSTITIUTE ANSUBSTITIUTE AN
SUBSTITIUTE ANSUBSTITIUTE AN
SUBSTITIUTE AN
INCORRECTINCORRECT
INCORRECTINCORRECT
INCORRECT
ELEMENT MODELELEMENT MODEL
ELEMENT MODELELEMENT MODEL
ELEMENT MODEL
NUMBERNUMBER
NUMBERNUMBER
NUMBER
Elements may look almost identical but can differ by a
fraction of an inch in length - a difference that makes a
firm seal impossible. You're always better off using the
dirty element until you can get the correct model.
AIR CLEANER MAINTENANCE CONTINUED...
To Next Page
Loading...