EasyManua.ls Logo

Baseline 300 - ONE WORD FOR SAFETY: R.I.M.; READ: Tire and Rim Matching; INSPECT: Wheel and Tire Condition; MOUNT: Safe Tire Mounting Practices

Baseline 300
28 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
85610373 00 01/2016 © Copyright 2015 Hennessy Industries, Inc. All Rights Reserved.
ONE WORD FOR SAFETY
READ INSPECT MOUNT
BE CAREFUL OF THESE SITUATIONS:
1. Damaged Bead or
Beads.
2. Rusty Wheels.
(particularly in the
bead seat area)
3. Bent or Cracked
Wheels.
4 A. Mismatched.
(A mis-match of a
16-inch tire to a 16.5-
inch rim causing an
explosion)
4 B. Mismatched.
(16.5-inch tire on a
16-inch rim)
5. Walk-In Tire and
Rim.
6. Back Injuries.
7. Hand or Finger
Injuries.
(Hands or fingers too
close to inflating tire
or bead seats which
may cause injury.)
8. Standing Clear.
(Never put any part
of your body over the
tire changer during
inflation.)
9. Beads will not
Seat at 40 PSI.
10. Improper
Inflation.
READ…
Mounting and inflat-
ing the wrong size tire
can get you hurt. Read
the size on the tire and
make sure it matches the
rim. Be especially careful
about putting a smaller
tire on a larger rim, such
as a 16-inch tire on a 16.5-
inch rim.
Inflation of a mismatched
tire and rim can cause an
explosion.
INSPECT
Before you put any tire
on a rim, Inspect the rim
for rust, tough spots, bent
edges, or cracks that
could prevent the tire from
seating right. If you spot
any of these problems,
don’t mount the tire until
the rim has been checked
by your shop foreman.
Inspect the tire for bead
damage.
MOUNT
Once you’ve made sure the tire is
OK and the right size and the rim is
OK, Mount the tire safely. NEVER, ever
lean over the tire when you’re inflat-
ing it. If a tire does explode, it will go
straight up. You don’t want to be over
the tire if that happens. Also, never
over-inflate the tire, even if the bead
doesn’t seat. Never inflate over 40 PSI.
If the tire hasn’t seated, something is
wrong. Deflate the tire and check it
and the rim again. If it doesn’t work
the second time, try another tire.
R.I.M.
FAILURE TO READ AND FOLLOW ALL WARN-
INGS AND INSTRUCTIONS IN THIS MANUAL
CAN LEAD TO SERIOUS PERSONAL INJURY
OR DEATH TO OPERATOR OR BYSTANDER.
THE OWNER IS RESPONSIBLE FOR MAIN-
TAINING THE OPERATION INSTRUCTIONS
AND DECALS FOR OPERATOR REFERENCE.
FOR ADDITIONAL COPIES, CONTACT HEN-
NESSY INDUSTRIES, INC., 1601 J.P. HEN-
NESSY DRIVE, LAVERGNE, TENNESSEE,
37086, (800) 688-6359.
TIRE FAILURE UNDER PRESSURE IS HAZ-
ARDOUS! This tire changer Will Not Restrain
Exploding Tires, rims or other related
equipment.
TIRES CAN EXPLODE, ESPECIALLY IF
INFLATED BEYOND SPECIFIED LIMITS. DO
NOT EXCEED TIRE MANUFACTURERS REC-
OMMENDED AIR PRESSURE.
AN EXPLODING TIRE, RIM, OR BEAD SEAT-
ING EQUIPMENT MAY PROPEL UPWARD
AND OUTWARD WITH SUFFICIENT ENERGY
TO CAUSE SERIOUS INJURY OR DEATH TO
OPERATOR AND/OR BYSTANDERS.
Remember R.I.M. (Read, Inspect, Mount) for every tire.

Related product manuals