Need help?Do you have a question about the BASIC DC Solareg II and is the answer not in the manual?
General| Output | PWM |
|---|---|
| Control Accuracy | ±1°C |
| Protection | Overload, Short Circuit, Reverse Polarity |
| Input Voltage | 12V DC |
| Output Voltage | 12V DC |
| Dimensions | 80 x 60 x mm |
Provides critical safety warnings for installation, wiring, and operation of the device.
Provides guidelines for 12V connections, recommended battery types, and switching output.
Details the connection of PT1000 sensors, cable specifications, and wiring practices.
Details how to operate the controller using the four buttons and navigate menus.
Explains the programming menu for adjusting operating parameters like max temperature and switch-on differences.
Illustrates the system with one collector and one storage tank, including connection points.
Details the collector protection function, which switches off the pump if the tank is too hot.
Lists faults with error messages, their possible causes, and recommended measures.
Details faults without error messages, possible causes, and troubleshooting measures.
To Next Page