Basler DGC-2020ES - Page 112

13-12 9469200995
BESTlogic™Plus DGC-2020ES
Name
Description
Symbol
Pre-Alarms
Battery Charger
Fail
True when the Battery Charger Fail function is
configured as a pre-alarm and the activation delay
has expired.
Battery Charger
AC Off
True when the ac power to the battery charger is off.
(Battery Charger 1 shown.)
Battery Charger
Battery Failure
True when the battery charger has detected that the
battery has failed. (Battery Charger 1 shown.)
Battery Charger
Comms Fail
True when the battery charger has detected a J1939
communications failure. (Battery Charger 1 shown.)
Battery Charger
Fail
True when the battery charger has failed. (Battery
Charger 1 shown.)
Battery Charger
High Output
Volts
True when the battery charger output voltage is too
high. (Battery Charger 1 shown.)
Battery Charger
Invalid Settings
True when the battery charger has detected invalid
settings. (Battery Charger 1 shown.)
Battery Charger
Low Cranking
Volts
True when the battery charger has detected that the
voltage while the engine is cranking has dipped too
low. (Battery Charger 1 shown.)
Battery Charger
Low Output
Volts
True when the battery charger output voltage is too
low. (Battery Charger 1 shown.)
Battery Charger
Single Unit Fail
True when the battery charger has detected one or
more charging output stages in a charger with
multiple charging output stages has failed. (Battery
Charger 1 shown.)
Battery Charger
Thermal Limit
True when the battery charger temperature is
beyond the thermal limit. (Battery Charger 1 shown.)
Battery
Overvoltage
True when the Battery Overvoltage pre-alarm
threshold has been exceeded.
Cannot Regen -
Interlock Fail
True when the regeneration interlock has failed on a
Yanmar ECU. Manual regeneration is blocked.
Cannot Regen -
Low Coolant
Temp
True when the coolant temp is low on a Yanmar
ECU. Manual regeneration is blocked.
Cannot Regen -
Not 50 Hours
Since Last
Regen
True when 50 hours has not elapsed since last
regeneration on a Yanmar ECU. Manual
regeneration is blocked.
Checksum
Failure
True when some of the user settings or firmware
code has been corrupted. Refer to the Reporting
and Alarms chapter for more details.