9469200995 13-13
DGC-2020ES BESTlogic™Plus
Expansion
Module
Multiple Contact
Expansion
Modules
True when more than one CEM-2020 is connected.
Expansion
Module
Contact
Expansion
Module Comm
True when communication from the CEM-2020 to
the DGC-2020ES has been lost.
Expansion
Module
Contact
Expansion
Modules
Hardware
True when the connected CEM-2020 does not have
the same number of outputs as defined on the
System Parameters, Remote Module Setup screen
in BESTCOMSPlus.
Sender Fail
True when the Coolant Temp Sender Fail is
configured as a pre-alarm and the activation delay
Consumption
True when the engine ECU reports via CAN bus that
a DEF Consumption Error has occurred.
Inducement
This is the lowest level of inducement not to operate
the engine when Diesel Exhaust Fluid (DEF) is low
or of poor quality or there is a problem with the
Exhaust After Treatment System (EATS). The
engine is operating in a reduced power mode.
Eventually the level of inducement will be increased
unless the problem with the DEF or malfunction in
Severe
True when the engine ECU reports via CAN Bus
that Diesel Exhaust Fluid (DEF) is at a level below
True when the engine ECU reports via CAN Bus
that the Diesel Exhaust Fluid (DEF) is at a level
Inducement
This pre-alarm indicates a temporary override of
inducement not to operate the engine. This is set by
the ECU and is not a user setting.
Inducement
This pre-alarm indicates a high level of inducement
not to operate the engine due to low or poor quality
Diesel Exhaust Fluid (DEF), or a malfunction in the
Exhaust After Treatment System (EATS). The
engine may operate in a reduced power mode, or for
a limited time, after which it will enter a state of
severe inducement unless the problem with the DEF
or malfunction in the EATS is corrected.
DEF Quality
Poor
True when the engine ECU reports “DEF Quality
Poor” via CAN Bus.
To Next Page
