Basler DGC-2020ES User Manual

9469200995 2-3
DGC-2020ES Configuration through the Front Panel
● CONFIGURE DATE/TIME
○ YEAR
○ MONTH
○ DAY
○ HOURS
○ MINUTES
○ SECONDS
○ UTC OFFSET
○ DST ENABLED
○ CLK NOT SET WRN
● VIEW DATE/TIME
● VERSION INFO
○ DGC-2020ES
■ FIRMWARE VERSION
■ BOOT CODE VERSION
■ SERIAL NUMBER
■ PART NUMBER
■ MODEL NUMBER
■ LANGUAGE VERSION
■ LANGUAGE PART NUM
■ FONT VERSION
■ FONT PART NUM
■ STYLE CODE
○ CEM-2020 (Visible when CEM-2020 is enabled.)
■ FIRMWARE VERSION
■ BOOT CODE VERSION
■ SERIAL NUMBER
■ PART NUMBER
■ MODEL NUMBER
■ BUILD DATE
COMMUNICATIONS
∗
∗(Visible when the optional J1939 CAN bus is enabled, style code xCx.)
● CAN BUS SETUP
○ CAN BUS SETUP
■ CAN BUS ENABLE
■ DTC ENABLE (Visible when CAN BUS is enabled.)
■ SPN CONV METHOD (Visible when CAN BUS is enabled.)
■ CAN BUS ADDR (Visible when CAN BUS is enabled.)
■ ENGINE ECU ADDRESS (Visible when CAN BUS is enabled.)
■ ECU OPT SLCT (Visible when CAN BUS is enabled.)
■ ECU PULSING (Visible when CAN BUS is enabled.)
■ ENG SHTDN TM (Visible when CAN BUS is enabled.)
■ PLS CYCL TM (Visible when CAN BUS is enabled.)
■ ECU SET TM (Visible when CAN BUS is enabled.)
■ RESP TIMEOUT (Visible when CAN BUS is enabled.)
■ COOL TEMP SRC (Visible when CAN BUS is enabled.)
■ OIL PRESS SRC (Visible when CAN BUS is enabled.)
■ ENGINE RUN TM SRC (Visible when CAN BUS is enabled.)
○ ECU SETUP (Visible when CAN BUS is enabled.)
■ ECU CONF
■ CUMMINS ECU SETUP
□ CUMMINS GEN CONTROL
■ ISUZU ECU SETUP
□ CLEAR ECU MEMORY
□ ESCAPE MODE
■ YANMAR ECU SETUP
□ NUMBER OF CYLINDERS
■ GEN DATA TRANSMIT
■ ENGINE PARAM XMT
■ TRIP RESET (Visible when ECU is configured for Standard, Volvo Penta, MTU ADEC,
GM/Doosan, Cummins, or MTU Smart Connect.)
■ START MODE

Basler DGC-2020ES Specifications

General

Brand	Basler
Model	DGC-2020ES
Category	Controller
Language	English