Basler DGC-2020ES User Manual

9469200995 2-5
DGC-2020ES Configuration through the Front Panel
□ MODE SWITCH (Visible when ECU is configured for MTU MDEC 304, or MTU
ECU7/ECU8.)
□ GOV PARAM SET (Visible when ECU is configured for MTU ECU7/ECU8.)
□ CAN RATING SW 1 (Visible when ECU is configured for MTU ECU7/ECU8.)
□ CAN RATING SW 2 (Visible when ECU is configured for MTU ECU7/ECU8.)
□ DIS CYL CUT 1 (Visible when ECU is configured for MTU MDEC 304, or MTU
ECU7/ECU8.)
□ DIS CYL CUT 2 (Visible when ECU is configured for MTU MDEC 304, MTU
ECU7/ECU8 or MTU Smart Connect.)
□ OPERATING MODE (Visible when ECU is configured for MTU Smart Connect.)
SYSTEM PARAMS
● SYSTEM SETTINGS
○ GEN CONNECT
○ BUS CONNECT
○ RATED kW
○ RATED VOLTS
○ RATED FREQ
○ ALTRNATE FRQ
○ RATED RPM
○ RATED PF
○ ROTATION
○ EPS
■ EPS THRESHLD
■ LOW LINE SF (Visible when an input is selected for the Low Line Override programmable
function.)
○ FUEL LVL TYP
○ SYSTEM UNITS
○ PRESSURE UNITS (Visible when Metric is selected for System Units.)
○ BATTERY VOLT
○ FLYWHL TEETH
○ SPEED SOURCE
○ MAINT RESET
○ NFPA LEVEL
○ POWER UP DELAY
● REMOTE MODULE SETUP
○ CEM SETUP
■ ENABLE
■ OUTPUTS (Visible when CEM-2020 is enabled.)
■ CAN BUS ADDR (Visible when CEM-2020 is enabled.)
■ VERSION INFO (Visible when CEM-2020 is enabled.)
□ FIRMWARE VERSION
□ BOOT CODE VERSION
□ SERIAL NUMBER
□ PART NUMBER
□ MODEL NUMBER
□ BUILD DATE
■ CEM DEBUG MENU (Visible when CEM-2020 is enabled.)
□ DGC TO CEM BP
□ CEM TO DGC BP
● CRANK SETTINGS
○ DISCNCT LMIT
○ PRECRNK DELY
○ PRESTRT CNTCT
○ STYLE
○ # CYCLES (Visible when Cycle is selected for Cranking Style.)
○ CONT TIME (Visible when Continuous is selected for Cranking Style.)
○ CYCLE TIME
○ REST TIME
○ COOLDWN TIME
○ COOLDOWN CONFIG
○ RESTART DELAY
○ OFF MODE COOLDN

Basler DGC-2020ES Specifications

General

Brand	Basler
Model	DGC-2020ES
Category	Controller
Language	English