Bauer 1632E-B - Specifications and Setup; Initial Setup and Assembly

Page 8 <&(%$*4.8"4,7%J'*#$"&8#K%/7*,#*%4,77%HLMMMLMIILNOPO1 Item 63438
?@<6AQ RS6;@ACRE D@CEA6E@ET6?6AFS
?/*4"2"4,$"&8#
Electrical Input 120 VAC / 60 Hz / 15 A
No Load Blows
Per Minute
1300 BPM
Chisels
1 Bull Point (included)
1 Flat Point (included)
Other
Accessories
Chisel Grease
Carbon Brush Set
aHNIOMO
%?*$'/%L%W*2&(*%F#*-
% ;*,9%$.*%6EAC;6%CDSR;A@EA%?@<6AQ%CE<R;D@ACRE%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*\$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
E&$*- For additional information regarding the parts listed in the
following pages, refer to Parts List and Diagram on page 14.
@##*5+7>
The only assembly required for the
Demolition Hammer is the positioning of the
Auxiliary Handle around the Cylinder Case.
1. Twist Auxiliary Handle into desired position.
2. Tighten Auxiliary Handle Knob to
fasten Auxiliary Handle in place.