Page 7<&(%$*4.8"4,7%K'*#$"&8#L%/7*,#*%4,77%HMNNNMNIIMOPQP1Item 63444
?@<6ARST6;@ACSED@CEA6E@EU6 ?6AFT
6\$*8#"&8%U&(9#
1. Grounded tools require a three wire extension cord.
Double Insulated tools can use either
a two or three wire extension cord.
2. As the distance from the supply outlet increases,
you must use a heavier gauge extension cord.
Using extension cords with inadequately sized wire
causes a serious drop in voltage, resulting in loss of
power and possible tool damage. ]?**%A,+7*%@1^
3. The smaller the gauge number of the wire, the
greater the capacity of the cord. For example,
a 14 gauge cord can carry a higher current
than a 16 gauge cord. ]?**%A,+7*%@1^
4. When using more than one extension cord
to make up the total length, make sure
each cord contains at least the minimum
wire size required. ]?**%A,+7*%@1^
5. If you are using one extension cord for more
than one tool, add the nameplate%amperes
and use the sum to determine the required
minimum cord size. ]?**%A,+7*%@1^
6. If you are using an extension cord outdoors, make
sure it is marked with the suffix “W-A” (“W” in
Canada) to indicate it is acceptable for outdoor use.
7. Make sure the extension cord is properly wired
and in good electrical condition. Always replace
a damaged extension cord or have it repaired
by a qualified electrician before using it.
8. Protect the extension cords from sharp objects,
excessive heat, and damp or wet areas.
A@XG6%@-%%;6USDD6EY6Y%DCECDFD%VC;6%
W@FW6%<S;%6bA6E?CSE%US;Y?c%]Had0aed%!SGA^
E@D6TG@A6
@DT6;6?
],$%2'77%7&,9^
6bA6E?CSE%US;Y%
G6EWAB
aOf Odf POf Hddf HOdf
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
c%X,#*9%&8%7"5"$"83%$.*%7"8*%Z&7$,3*%9(&/%$&%2"Z*%Z&7$#%,$%
HOdg%&2%$.*%(,$*9%,5/*(*#1
?>5+&7&3>
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
!
Volts
h
Alternating Current
@
Amperes
n
0
xxxx/min.
No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking
concerning Risk of Fire.
Do not cover ventilation ducts.
Keep flammable objects away.
WARNING marking concerning
Risk of Electric Shock.
Properly connect power cord
to appropriate outlet.
To Next Page
Loading...
