Page 10 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 57179
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
Q&(X%F(*,
1. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
3. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
E,)%S7,9*%E*7*4$"&8
1. Any saw blade that will be used must be
marked as suitable for the material to be cut.
2. Use only a saw blade diameter in
accordance with the markings on the saw.
See specification table for the bore diameter
and the maximum kerf of the saw blade.
3. Use only saw blades that are marked with a speed
equal or higher than the speed marked on the tool.
R',(9%E*$'/
Check that the Lower Blade Guard is in place,
moves freely, and closes instantly.
U'#$%6Z$(,4$"&8%E*$'/
1. To use the Dust Collection Bag, slide the Bag
over the Dust Outlet at the rear of the Saw Head
Assembly. Refer to Assembly on page 8.
2. The Dust Outlet also accepts a 1-1/2"
vacuum hose to use a dust collection
system instead of the Dust Bag.
To Next Page
Loading...
