Bauer 1974E-B - Operating Instructions; Tool Changing

Page 11>"-&#$95<19)(&?2$+#1"<+@&,($)+$&9)((&ABCCCBCDDBEFGF/Item 57151
HI>;JKLM;NIJOL!PIO!J;!I!Q; H;JRM
L,$-)#1<8&O<+#-29#1"<+
&N$)*&#5$&;!JON;&OPMLNJI!J&HI>;JK&O!>LNPIJOL!&+$9#1"<&)#&#5$&4$81<<1<8&"7&#51+&
:)<2)(&1<9(2*1<8&)((&#$Z#&2<*$-&+245$)*1<8+&#5$-$1<&4$7"-$&+$#&2,&"-&2+$&"7&#51+&,-"*29#/
J""(&Q5)<81<8
!"#$% Replacement blade sold separately.
1. Unplug the tool from its power source.
2. Pull out the Head Lock-Down Pin, raise the Saw
Head to the upper position, then raise the Lower
Blade Guard out of the way and hold it up.
3. Loosen the Guard Plate Bolt until it
disengages the Guard Plate.
4. Swing the Guard Plate up and out of the way.
U"3$-&
'()*$&
T2)-*
T2)-*&
M()#$
T2)-*&
M()#$&
'"(#
I-4"-&
'"(#
>182-$&Q
5. Press in the Spindle Lock on the back
of the saw′s head and hold it in.
6. Remove the Arbor Bolt, and Outer Flange.
Refer to Figure D. &
OPMLNJI!J%&&J5$&I-4"-&'"(#&5)+&)&($7#B5)<*$*&
#5-$)*&)<*&-$:"W$+&4.&#2-<1<8&QULQYSOH;/
>182-$&V
L2#$-&
>()<8$
O<<$-&
>()<8$
H,1<*($
'()*$
I-4"-&
'"(#
!"#$% Make sure the Inner Flange
stays in place on the Spindle.
7. Remove the used blade. Install the new Blade.
Make sure that the Blade′s rotation arrow
,"1<#+&1<&#5$&+):$&*1-$9#1"<&)+&#5$&-"#)#1"<&
)--"3&"<&#5$&R,,$-&'()*$&T2)-*/
8. Replace the Outer Flange, Flat Washer,
and Arbor Bolt. Position the cupped side of
the Flange against the Blade. Hold in the
Spindle Lock and wrench tighten the Arbor
Bolt by turning it QLR!J;NQULQYSOH;.
Release the Spindle Lock.
9. Rotate the Guard Plate back into place,
and secure it with the Guard Plate Bolt.
10. SIN!O!Ti&&JL&MN;0;!J&H;NOLRH&O!jRNK%&&
P)X$&+2-$&#5$&U"3$-&'()*$&T2)-*&",$-)#$+&
+:""#5(.&)<*&,-",$-(.&,-"#$9#+&7-":&
#5$&'()*$&4$7"-$&2+1<8&#5$&H)3/