Bauer 1974E-B - Aligning the Fence; Using the Depth Stop; Kerf Board Replacement;Adjustment

Page 13>"-&#$95<19)(&?2$+#1"<+@&,($)+$&9)((&ABCCCBCDDBEFGF/Item 57151
HI>;JKLM;NIJOL!PIO!J;!I!Q; H;JRM
I(18<1<8&#5$&>$<9$
1. After adjusting the miter, bevel, or depth setting,
check and adjust both sides of the Fence.
2. Loosen one of the Fence Lock Knobs, and move
its Sliding Fence to be within 1/8" of the blade.
3. Tighten the Fence Lock Knob. Make sure that the
Sliding Fence still does not contact the Blade.
4. Repeat the process for the other Fence
Lock Knob and Sliding Fence.
R+1<8&#5$&V$,#5&H#",
If a kerfing or rabbet cut which does not cut
through the workpiece is desired, use the
Depth Stop to control the depth of the cut.
1. Pull out the Head Lock-Down Pin and
raise the Saw Head Assembly.
2. Rotate the Depth Stop down to a horizontal
position to use the Depth Adjustment Bolt setting.
3. Pull down on the Saw Head to
check the current setting.
4. To change the setting, first loosen the Lock
Nut on the Depth Adjustment Bolt. Turn the
Depth Adjustment Bolt clockwise to decrease
depth and counterclockwise to increase depth.
Tighten the Lock Nut after adjustment.
V$,#5&V$,#5&
I*]2+#:$<#&I*]2+#:$<#&
'"(#'"(#
U"9X&!2#
V$,#5&
H#",
>182-$&T
5. To disengage, rotate the Depth Stop
up to its vertical position.
Kerf Board Replacement / Adjustment
If the Kerf Boards become damaged
they must be replaced.
1. Remove the six screws holding the two Kerf
Boards in place and lift them from the Saw.
2. Install the new Kerf Boards, placing them
on either side of the cut line. Replace the
six screws and tighten them slightly.
J"&)*]2+#&#5$&Y$-7&'")-*+%
1. Lower the Saw Head Assembly and lock it
down with the Head Lock-Down Pin.
2. Check for blade clearance by moving the Saw
Head through its full range of motion with the
bevel angle set at 0º, at maximum left bevel
angle, and at maximum right bevel angle. Refer
to Adjusting the Bevel Angle on page 12.
3. If the Saw Blade hits either of the Kerf
Boards, loosen the three screws for that
Board and adjust. Tighten the screws
and check again for blade clearance.
Y$-7&Y$-7&
'")-*'")-*
Y$-7&Y$-7&
'")-*'")-*
H9-$3H9-$3
>182-$&_
4. After verifying blade clearance, tighten the six
screws holding the Kerf Boards in place.