Page 12 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 56250
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
N,"8$*8,84*%,89%E*(W"4"83%L8#$('4$"&8#
%J(&4*9'(*#%8&$%#/*4"2"4,77V%*Z/7,"8*9%"8%$."#%5,8',7%5'#$%
+*%/*(2&(5*9%&87V%+V%,%<',7"2"*9%$*4.8"4",81
GI%JK6!6MG%E6KLIPE%LMiPKH%;KIN%FOOLU6MGFT%IJ6KFGLIM-%
N,X*%#'(*%$.,$%$.*%G("33*(%"#%"8%$.*%&22?/&#"$"&8%,89%'8/7'3%$.*%$&&7%2(&5%"$#%
*7*4$("4,7%&'$7*$%+*2&(*%/*(2&(5"83%,8V%/(&4*9'(*%"8%$."#%#*4$"&81
GI%JK6!6MG%E6KLIPE%LMiPKH%;KIN%GIIT%;FLTPK6-%
U&%8&$%'#*%9,5,3*9%*<'"/5*8$1%%L2%,+8&(5,7%8&"#*%&(%W"+(,$"&8%
&44'(#=%.,W*%$.*%/(&+7*5%4&((*4$*9%+*2&(*%2'($.*(%'#*1
O7*,8"83=%N,"8$*8,84*=%,89%T'+("4,$"&8
1. S6;IK6%6FO_%PE6= inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2. F;G6K%PE6= wipe external surfaces
of the tool with clean cloth.
3. Periodically blow dust and grit out of the motor vents
using dry compressed air. Wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection while doing this.
4. Check the condition of Blades regularly.
Bent, cracked, worn or dull blades will not
operate properly and can cause damage or
injury. Discard damaged or worn blades.
5. For blade changing instructions see Installing
the Saw Blade in Tool Set Up on page 9.
6. QFKMLMRj%%L2%$.*%/7'3%&(%$.*%#'//7V%4&(9%
&2%$."#%/&)*(%$&&7%"#%9,5,3*9=%"$%5'#$%+*%
(*/7,4*9%&87V%+V%,%<',7"2"*9%#*(W"4*%$*4.8"4",81
To Next Page
Loading...
