Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 56250
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
I/*(,$"83%L8#$('4$"&8#
%K*,9%$.*%6MGLK6%LNJIKGFMG%EF;6GH%LM;IKNFGLIM%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*Z$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
G&&7%E*$%P/
GI%JK6!6MG%E6KLIPE%LMiPKH%;KIN%
FOOLU6MGFT%IJ6KFGLIM-%
K*7*,#*%$.*%G("33*(=%5,X*%#'(*%$.*%G("33*(%
T&4X%"#%8&$%*83,3*9%,89%'8/7'3%$.*%$&&7%
2(&5%"$#%*7*4$("4,7%&'$7*$%+*2&(*%,9]'#$"83%
$.*%$&&7%&(%"8#$,77"83%,44*##&("*#1
L8#$,77"83%$.*%E,)%S7,9*
1. If there is an installed blade, remove it by
opening the Chuck and pulling the blade out.
To open the Chuck, rotate it counterclockwise
and hold it in the open position.
2. Release the Chuck to close it.
3. To install the new Saw Blade, rotate and hold the
Chuck counterclockwise while inserting the Saw
Blade and pushing it in to its deepest position.
4. Release the Chuck to close it.
5. Check that the Saw Blade is firmly locked in
place and that the teeth are pointed downward.
QFKMLMRj To prevent serious injury: Before
plugging in the Power Cord for each use, wearing
work gloves, pull on the Saw Blade to make
sure it is securely locked in the Chuck.
F9]'#$"83%$.*%E.&*
_*Z%Y*V
O,/%E4(*)#
E.&*
;(&8$%O&W*(
1. The retracted blade length should be longer
than the width of the workpiece. If the Blade
is shorter, the tip will jam in the workpiece
during cutting, possibly causing injury and
damaging the Blade or workpiece. To adjust
the Shoe and the Blade extension:
2. Loosen both Cap Screws on the
underside of the Front Cover.
3. Adjust the Shoe in or out as needed.
4. Tighten the Cap Screws. Do not over tighten.
To Next Page
Loading...
