BAUKER SBC30 - Maintain the Saw in Good Working Order; Have all chain saw service performed by a qualified service dealer; Make certain the saw chain stops moving when the throttle trigger is released.; Carburetor Adjustment

EN-12
Continual and regular users should have their hearing checked
regularly.
MAINTAIN THE SAW IN GOOD WORKING ORDER
1. Have all chain saw service performed by a qualied service
dealer with the exception of the items listed in the maintenance
section of this manual. For example, if improper tools are
used to remove or hold the ywheel when servicing the clutch,
structural damage to the ywheel can occur and cause the
ywheel to burst.
2. Make certain the saw chain stops moving when the throttle
trigger is released.
Carburetor adjustment
1. Never modify your saw in any way.
2. Keep the handles dry, clean, and free of oil or fuel mixture.
3. Keep fuel and oil caps, screws, and fasteners securely
tightened.
4. Use only qualied accessories and replacement parts as
recommended.
Handle fuel with caution
1. Do not smoke while handling fuel or while operating the saw.
2. Eliminate all sources of sparks or ame in the areas where fuel
is mixed or poured. There should be no smoking, open ames,
or work that could cause sparks. Allow engine to cool before
refueling.
3. Mix and pour fuel in an outdoor area on bare ground; store
fuel in a cool, dry, well ventilated place; and use an approved,
marked container for all fuel purposes. Wipe up all fuel spills
before starting saw.
4. Move at least 3 meters from fueling site before starting engine.
5. Turn the engine off and let saw cool in a non-combustible
area, not on dry leaves, straw, paper, etc. Slowly remove fuel
cap and refuel unit.
6. Store the unit and fuel in an area where fuel vapors cannot
reach sparks or open ames from water heaters, electric
motors or switches, furnaces, etc.