Baumatic BAD4504 - Cleaning the Filter; Cleaning the Door; Protect against Freezing; Cleaning the Spray Arms

Th e c o ntro l p an el ca n be cle aned by u sing a li ghtly dam pened c l oth .
After cle anin g, m ake sur e to dry i t t ho roug hly.
For the exter ior, use a go od a ppl iance polis h wax.
Ne ve r us e shar p o bjects, scou rin g p ad s or har sh c l eaner s on any p ar t o f t he dishwasher.
ProtectAgainst Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn o ff th ew ater s upply an d disco nnec t the wa ter i nlet pipe from the water v alve .
3.D rain the wat er f rom th e inl et p ipe a nd w ater val ve. (Use a pa n to cat ch th e wa ter)
4.Reconnect the water inlet pipe tothe water valve.
5.R e move the fi lt e r at the b ott om of t he t ub and u se a spo nge to s oak u p w ater i n th e s ump.
please t ake fros t pro tect ion m eas ures on the dish was her in wi nter. Eve ry fter wa shing c ycles,
pl e ase op e rat e as f ol lo ws
time a
：
- Inspec t t he filte rs for blo cki ng a fter e very time th e di shwasher ha s been used.
- By unscr ew ing the coarse f ilter, you can r em ove the filter syst em. Re move an y fo od r emn ants and
clean t he filt ers under r unning w ater.
Remarks:
Cleaning the Filter
Cleaning The Door
To c lean the coa rsef i lter and the f ine fil te r, us e a c lean in g b rus h. R eas semble t he f ilter p art s as shown in the fi gu res
on t he la st p age and r ein sert t he entire assemb ly in the dis hwasher, positio ning it i n it s seat and pressi ng downw ards .
The entire filter assembly should be cleaned once a week.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of the dishwasher could be decreased.
To c lean the edge around the doo r, yo u sh ould u se only a s oft wa rm, da mp clot h.
To a void pen etra tion of water into the door loc k an d elect rical c omp one nt s, do n ot
use a sp ray cleaner of any kind.
Never u se a spr ay cl eaner t ocl ean the door pane l a s it m ay damage the door lock
and electrical components.
Abrasive agentsor some paper towels shouldnotbe used because of theriskof
scratchi ng or l eaving spots on th es tainless ste el sur fac e.
Cleaning the Spray Arms
If your dis hwasher cannot work because of t he ic e,
pl ease cont act professi onal service pe rsons.
It is n ecessary to cl ean the spra y a rms regular ly fo r hard
wate r c hemicals w ill cl og the sp ra y ar m j ets a nd b earings.
To remove th e spra y ar ms, screw off the n ut clock wise t o
take out t he wa sher on t op of t he spray a rm a nd rem ove
thearm.
Wash the arm s in soap y an d war m w ater an d u se a sof t
brush to c lean the jets. Rep lace t hem after rinsi ng them
thoroughly.
12