15
Residual heat indicator
o After a zone is switched off, the corresponding
cooking zone indicator (7) will show a flashing
letter “H”. This means that the temperature of the
zone is over 60°C and is therefore still high enough
to cause injury.
o IMPORTANT: The residual heat indicator will disappear if your
mains supply is cut.
Pan sensor
Each zone has a sensor on it, so it can detect the presence of a pan.
o The sensor is fine-tuned to detect a pan being placed on it. The
pan should be one size smaller than the nominal diameter of the
zone.
o If after placing a pan on a cooking zone and selecting that
cooking zone, a “U” shaped symbol appears on the cooking zone
indicator (7). This means that the pan is either the incorrect size
or shape. Or it could be made from a material that is
inappropriate for use on an induction zone hob.
o If a cooking zone is selected but no pan is detected, the pan
sensor system will check for the presence of a pan
approximately every few seconds.
o You should check that your pans are suitable for use on an
induction zone hob (see the pan manufacturer’s trademark or
instructions).
To Next Page
Loading...
