28
o Only two of the zones on my hob are working
* You should recheck that the terminal screws are all fully
tightened between the links.
Error codes
The following error codes may appear in the timer display if there is a
problem with the operation of the hob.
Fault Possible cause Solutions
FO/F1/F2 Fan failure Contact the Customer Care Department
F3 – F8 Temperature
sensor failure
Contact the Customer Care Department
E1 – E2 Abnormal voltage
from the mains
supply
Check whether the power supply is
operating normally.
E3 – E4 Abnormal
temperature
Check that the pan is of the correct size
to be used on a particular zone. If the
pan is correctly sized and the error code
reappears, contact the Customer Care
Department.
E5 – E6 Poor heat
radiation from a
cooking zone
Allow the appliance to cool down and
then use the cooking zone again. If the
error code reappears, contact the
Customer Care Department.
To Next Page
Loading...
