24
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o There are holes on the base of the hob that you can fix the two
brackets to.
o You should place the
bracket on the
underneath of the hob,
in a position that is
appropriate for the
aperture that you have
cut out. Using the
screws provided, fix the
bracket to the hob.
These screws MUST be
securely tightened.
To Next Page
Loading...
