Replacing the mains supply cable
o If the mains supply cable is damaged, then it must be replaced
with a suitable replacement.
o The mains supply cable should be replaced in accordance with
the following instructions:
o Switch the appliance off at the socket.
o Open the terminal block on the back of the oven.
o Unscrew the terminal screws fixing the cable.
o Replace the cable with one of the same length and in accordance
with the specification.
o The “green-yellow” earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and
neutral wires.
o The “blue” neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
o The connection cable must be secured in a strain-relief clamp.
To Next Page
Loading...
