EasyManua.ls Logo

Baumatic BT06.8ME - Cleaning and Maintenance; General Cleaning Procedures; Grease Filter Maintenance

Baumatic BT06.8ME
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
Cleaning your Baumatic cooker hood
IMPORTANT: BEFORE CLEANING, ALWAYS ENSURE
THAT YOU HAVE SWITCHED YOUR COOKER HOOD
OFF
AT THE OMNI-POLAR SWITCH, SET AT THE
WALL FROM THE CABLE.
Cleaning
o Clean the external parts of your cooker hood with mild liquid
detergent and a new damp cloth.
o Never use abrasive powder, corrosive solvents or brushes.
o Never insert pointed objects into the motor’s protective grid.
o Only clean the control panel and grease filter grill with mild liquid
detergents and a new damp cloth.
o If you are using the appliance in recirculation mode, then be
sure to replace the carbon filters at the recommended interval
(see section on “Fitting the carbon filter”). A build up of grease
could cause a fire hazard.
o Never attempt to clean the area above the grease filter.
The grease filter
o Your cooker hood includes a grease filter which helps to absorb
grease particles to protect your kitchen and furniture from
greasy residues.
o The synthetic filter may become flammable if it becomes
saturated with this greasy residue.
o To prevent this fire hazard, the filter should be replaced
occasionally. Depending on use, this should be done every 3
months, following the method shown in the next section.
o The synthetic grease filter is not washable.
o Replacement synthetic filters can be purchased from the
Baumatic Spares Department.

Related product manuals