27
The electrical connection must correspond to the electrical requirement
noted on the rating plate, which is placed inside the cooker hood. The
appliance should now be connected to the electrical supply. See page
18 – 19 for detailed information on the electrical connection.
Refit the grease filter(s) and then switch on the mains
supply to the appliance. Check that the appliance is
operating correctly by selecting each speed and switching
the light bulbs on and off.
Troubleshooting
IMPORTANT: If your cooker hood appears not to be
operating properly, before contacting the Baumatic
Service Department, please refer to the checklist
below.
My cooker hood will not start.
o Check that the hood is connected to the electricity supply
o Check that the fan speed control is set correctly.
My cooker hood is not working effectively.
o The fan speed is not set high enough
o The grease filter is dirty and requires replacing.
o The kitchen is not well ventilated enough.
o If the hood is set up for recirculation mode, check that the
carbon filters do not need replacing.
o If the hood is set up for extraction mode, check that the ducting
hose and discharge outlet are not blocked.
My cooker hood has switched off during operation.
o The safety cut-out device has been tripped.
To Next Page
Loading...
