16
o Once the bulb has been replaced, refit the panel by screwing the
screws back into place.
Fitting the carbon filter
If the appliance is going to be used in recirculation mode then it is
necessary to a fit a carbon filter. This will help to absorb unpleasant
odours caused by cooking.
IMPORTANT: BEFORE ATTEMPTING TO FIT OR
REMOVE THE CARBON FILTERS, YOU MUST
ENSURE THAT YOU HAVE DISCONNECTED THE
COOKER HOOD FROM YOUR MAINS SUPPLY.
o Remove the filter by locating the two catches at the base of the
grease filter, as shown in the diagram above (1).
o Insert a finger into each catch and gently lift and pull the filter
outwards (2).
To Next Page
Loading...
