20
Auto defrost
o Use the door release button to open the door of the microwave.
o Check that the turntable shaft, turntable ring assembly and glass
tray are correctly assembled in the cavity.
o Place whatever you are defrosting in the centre of the microwave
cavity.
o Press the Stop.Clear button (2) once when the colon flashes on
the LED display.
o Select the required defrost function by pressing the Auto Defrost
button (7).
o Press the Instant Start button (1) to confirm.
o You can then set the weight of the food by pressing the
Weight.Time.Temp button (8) to decrease and the Auto Cooking
button (6) to increase. The microwave will determine the
appropriate length of defrosting time according to the program
and weight selected.
o Close the microwave oven door and press the Instant Start
button (1) to begin cooking. The LED display will count down to
show the remaining cooking time.
o Half way through the defrosting process a beep will sound 3
times to prompt you to turn the food over. Open the door and
turn the food over, shielding the warm portion. Close the door
again and press the Instant Start button (1) to continue
defrosting. If you do not turn the food, the defrosting cycle will
continue until the end of the countdown time.
o If you wish to remove the food before the preset time, you must
press the Stop.Clear button (2) once to clear the preset program
to avoid unintended operation during next use.
o At the end of the cooking time, the LED display will show “End”
and 3 beeps will sound to prompt you to remove the food from
the microwave. If you do not press the Stop.
Clear button (2)
once or open the door, the beep will sound every 3 minutes.
o After the food has been removed from the microwave, you
should make sure that the door is closed.
To Next Page
Loading...
