Installation
The installation must be carried out by a suitably
qualified person, in accordance with the current
version of the following.
o UK Regulations and Safety Standards or their European
Norm Replacements.
o Building Regulations (issued by the Department of the
Environment).
o Building Standards (issued by the Scottish Development
Department).
o IEE Wiring Regulations.
o Electricity At Work Regulations.
Electrical connection
YOUR MICROWAVE IS INTENDED FOR FITTED AND
PERMANENT INSTALLATION.
o Before connecting the appliance, make sure that the supply
voltage marked on the rating plate corresponds with your mains
supply voltage.
o We recommend that the appliance is connected by a qualified
electrician, who is a member of the N.I.C.E.I.C. and who will
comply with the I.E.E. and local regulations.
o WARNING: THIS APPLIANCE MUST BE EARTHED.
o This appliance is supplied with a moulded plug, which must be
connected to an earthed socket.
o If in future you need to change the fuse in this plug, then a 13
amp ASTA approved (BS 1362) fuse must be used.
o If the earthed socket is not accessible after the appliance is
installed. Then the microwave must be wired into a 13 A double
pole switched fused spur outlet, having 3 mm contact separation
and placed in an easily accessible position adjacent to the
appliance. The spur outlet must still be accessible even when
your microwave is located in its housing.
o The wiring in the mains lead is coloured as follows:
Brown Live
Blue Neutral
Green and yellow Earth
31
To Next Page
Loading...
