o To access the rinse aid dispenser, you should turn the cap
anticlockwise and it will pop out of the hole (1). Then slowly
pour in liquid rinse aid (2).
o You should continue to fill with rinse aid, until the level indicator
turns completely black.
o Be careful not to overfill the dispenser, as this could cause
oversudsing when a wash program is selected. Wipe away any
rinse aid excess or spillages with a damp cloth.
o Replace the cap and turn it clockwise until it locks into position
(3).
o You should refill the rinse aid dispenser when the rinse aid
indicator neon lights on the control panel.
o IMPORTANT: If you are using 3 in 1 dishwasher tablets then
you should still fill the rinse aid dispenser.
Setting the rinse aid level
The amount of rinse aid that the dishwasher requires also depends on
the hardness of your water. You should experiment with the rinse aid
setting, until you find a level that gives the best results.
o On the first wash cycle, we would recommend
that the rinse aid level is set to number 2.
o If you get water spots and poor drying
performance, then you should turn the arrow
anticlockwise and increase the setting to the
next number.
o You should continue to adjust the rinse aid level upwards until
you get no water spots.
o If you get cloudiness or streaking on your dishes, the rinse aid
level is set too high and it is causing foaming during the wash
cycle. Turn the arrow clockwise and lower the setting to the next
number.
14
To Next Page
Loading...
