Before first use
You should check the following before using the appliance for the first
time:-
o That the dishwasher is level and fixed in position.
o That the water tap is fully open.
o That there are no leaks at either end of the drain or inlet hoses.
o That the inlet and outlet hose are fully tightened.
o That the inlet and outlet hoses are not kinked.
o That the power is switched on.
o That the water softener has been filled with 1 litre of water and
salt.
o That the rinse aid dispenser has been filled.
Error code failure system
If your appliance senses that it is not operating correctly, then a
program indicator neon may flash.
The following error codes can possibly be remedied by the customer
and the steps outlined below should be followed.
BEFORE COMPLETING ANY MAINTAINEANCE ON THE
APPLIANCE, IT SHOULD BE DISCONNECTED FROM YOUR MAINS
POWER SUPPLY.
Codes Meaning Possible causes
The RAPID light
flickers.
Longer water
inlet time.
Tap is not open, water intake is
restricted or water pressure is too
low.
The NORMAL
light flickers.
Overfilled. Too much inlet water.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button (1) and wait for 5
seconds, before attempting to set a wash program, using the
program selection button.
IMPORTANT: If any other of the program indicator neons
flash, you should not attempt to clear it yourself and
contact the Advice Line.
36
To Next Page
Loading...
